View Full Version : Rotating the connector on a CR9120 (OEM version of CR1051)

03-15-2012, 07:00 PM
I have a CR9120 and a Murr 90-degree overmolded cable. The keying is arranged so that the cable comes out of the connector and immediately turns towards the bottom edge of the screen (see photo).

Can I loosen the large nut on the controller connector and rotate the connector 90 degrees without causing harm to the screen?


Erik Gerrits
03-19-2012, 11:52 AM
I wouldn't recommend turning the connector. The connections are pretty short on the inside of the CR1050.

03-26-2012, 10:26 AM
Thanks. I didn't like that option either so I replaced the cable with a IFM straight M23 cable instead.