Kit, Germany never supported this feature so unfortunately I can't help you out on this. Its just not stable enough. Erik
Erik, I have been working on integrating the program “pdmNG-Controller CAN program loads” to a cr1083. It was originally posted on the forum as a cr1081 program that as I understand it is intended to allow the operator to use the USB port on a cr108x display to load programs and firmware on to CAN connected 16 or 32 bit controller. As far as my efforts are concerned I have had mixed success. I’ve got the program to run. I have accounted for the difference in buttons between a 1080 and a 1083 but I cannot get it to do what I assume it was written to do. Has anyone successfully implemented it? If so, do you have any example programs or any like it? Also I haven't been able to relocate the thread that the file came from so if you need me to send you a copy I can do so. Best regards, Kit Ayers Hydraulic Designer Cross Fluid Power Kit.ayers@crossco.com 336-291-2076
Home Page
Find latest posts