No More Results

2 Visitor Messages

  1. Kit,
    Germany never supported this feature so unfortunately I can't help you out on this. Its just not stable enough.

  2. View Conversation
    I have been working on integrating the program “pdmNG-Controller CAN program loads” to a cr1083. It was originally posted on the forum as a cr1081 program that as I understand it is intended to allow the operator to use the USB port on a cr108x display to load programs and firmware on to CAN connected 16 or 32 bit controller.

    As far as my efforts are concerned I have had mixed success. I’ve got the program to run. I have accounted for the difference in buttons between a 1080 and a 1083 but I cannot get it to do what I assume it was written to do.

    Has anyone successfully implemented it? If so, do you have any example programs or any like it?

    Also I haven't been able to relocate the thread that the file came from so if you need me to send you a copy I can do so.

    Best regards,
    Kit Ayers
    Hydraulic Designer
    Cross Fluid Power
Showing Visitor Messages 1 to 2 of 2
About Erik Gerrits

Basic Information

About Erik Gerrits
Minneapolis, MN
Product Specialist


Total Posts
Total Posts
Posts Per Day
Visitor Messages
Total Messages
Most Recent Message
10-05-2013 10:13 AM
General Information
Last Activity
04-15-2021 11:32 AM
Join Date
Home Page