Results 1 to 2 of 2

Thread: grayhill 3k-keypad

  1. #1
    Join Date
    Oct 2016
    Posts
    22

    Default grayhill 3k-keypad

    hi
    I try to work with gray hill 3k keypad can open via cr0032 .The following operation is been done:
    1. setting default value for baud rate and nod id (250kbps and node 0xA) .
    2. set NMT command "operational"
    3.termination resistor 120 ohm.
    I cant see any response from the keypad

    thank you in advance

  2. #2
    Join Date
    May 2009
    Location
    Minneapolis, MN
    Posts
    299

    Default

    It sounds like you have the CANopen version? Did you get an eds file and put that in your PLC configuration?

    You will need to save the EDS file here:
    C:\Program Files (x86)\ifm electronic\CoDeSys V2.3\Library\PLCConf

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •