Results 1 to 2 of 2

Thread: PWM Output on CR2032

  1. #1
    Join Date
    Jun 2016
    Location
    IA
    Posts
    16

    Default PWM Output on CR2032

    I am new to using the CR2032 and am having some issues configuring an output for PWM.

    Can someone point me in the right direction? In short, I simply need to configure one of the outputs to provide the PWM signal to a valve. I should mention that I am using a CAN based switch bank in which one set of switches will be using to increase/decrease the output value. I have not had any issues setting up the switch bank and CR2032 outputs as binary, but for some reason I am having a hard time wrapping my head around the PWM configuration.

    Any advice would be helpful.
    Ryan Benesch | Design Engineer, Ice Control
    DIR: (563) 927-7117
    rbenesch@hendersonproducts.com
    www.hendersonproducts.com

  2. #2
    Join Date
    May 2009
    Location
    Minneapolis, MN
    Posts
    300

    Default

    You need to send the SDO message to configure the output as PWM. The Object Dictionary takes care of this automatically if you use a ifm controller and the EDS file for the CR2032.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •