Results 1 to 2 of 2

Thread: PWM Output on CR2032

  1. #1
    Join Date
    Jun 2016

    Default PWM Output on CR2032

    I am new to using the CR2032 and am having some issues configuring an output for PWM.

    Can someone point me in the right direction? In short, I simply need to configure one of the outputs to provide the PWM signal to a valve. I should mention that I am using a CAN based switch bank in which one set of switches will be using to increase/decrease the output value. I have not had any issues setting up the switch bank and CR2032 outputs as binary, but for some reason I am having a hard time wrapping my head around the PWM configuration.

    Any advice would be helpful.
    Ryan Benesch | Design Engineer, Ice Control
    DIR: (563) 927-7117

  2. #2
    Join Date
    May 2009
    Minneapolis, MN


    You need to send the SDO message to configure the output as PWM. The Object Dictionary takes care of this automatically if you use a ifm controller and the EDS file for the CR2032.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts