What cables etc do I need to get connected with a CR2530 or CR2532?
There are a couple different ways to go about this:

Create your own cable harness:
  • CR2530 controller
  • EC2013 connector set
  • EC2112 CANfox USB to CAN adapter
  • EC2113 Connector cable for EC2112
  • EVC071 Cordset to connect CAN wires (black and grey) to the wiring harness
  • Additionally needed (2) 120 Ohm 1/4 Watt end resistors


Use cable sets to connect it all together
  • (1) CR2530 controller
  • (1) EC2096 programming cable (Important: Do not use the USB plug of this cable when connected to the CR253x!)
  • (1) EC2112 CANfox USB to CAN adapter
  • (1) EC2113 Connector cable for EC2112
  • (2) E18329 5 pin T - not listed on our website $44/per - in stock
  • (2) E11590 120 Ohm End resistor