Results 1 to 2 of 2

Thread: M12 CAN Splitter

  1. #1
    Join Date
    Sep 2010
    Burnsville, Minnesota

    Default M12 CAN Splitter

    Does anyone have a good source for a 5 wire M12 CAN splitter? I'm looking for either a Y cable or a T connector that has 1 to 1 wiring on all the pins so I can make a clean can junction on a basic display.
    David Grambsch
    Automation Controls Engineer

    FORCE America Inc.

  2. #2


    We use a Devicenet Y from Turck that is working just fine.

    We originally bought a Devicenet Tee from Turck (manufactured by someone else?). But we had quite a number of them fail. The failures were mechanical failures where stresses induced by tying three stiff cables into one small molded body caused cracks to appear over time. We switched to the Y's a couple of years back and the problems seem to be gone.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts