Results 1 to 3 of 3

Thread: changing finished software from cr0403 to cr0401

  1. #1
    Join Date
    Jun 2015
    Location
    Netherlands
    Posts
    20

    Default changing finished software from cr0403 to cr0401

    Hi all,

    I have developed software for a machine based on a cr0403 and cr0451 from the starter kit. The software is finished and now I would like to use a cr0401 for production. I have tried by simply selecting the CR0401 as new target in this finished software. I agreed with deleting the PLC configurations but then I checked the PLC configuration tab and the CR0403 is still there. It is possible to delete this but how do I get the correct one back in place, without this configuration file many identifiers are in error.

    How is this normally done?

    Bert

  2. #2
    Join Date
    Aug 2009
    Location
    ifm Exton, PA
    Posts
    196

    Default

    After you change the target, go to the PLC configuration (will still say CR0403).

    While viewing the PLC configuration you sect 'Extras' from the menu tab at the top, then select 'Standard Configuration'

    You will need to redo all your CAN settings in the PLC config (if you had any in the previous). Also you will need to change to the CR0401 library and delete the CR0403 library.

  3. #3
    Join Date
    Jun 2015
    Location
    Netherlands
    Posts
    20

    Default

    Thanks Jeremy, the cr0401 is up and running.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •