Results 1 to 3 of 3

Thread: Issue Connecting CR0032 to Downloader

  1. #1
    Join Date
    Aug 2016
    Posts
    26

    Default Issue Connecting CR0032 to Downloader

    I'm having issues connecting my CR0032 to download to install the firmware. I have Pin 10 and 50 connected to 12 V power with the PLC flashing fast green, I have Pin 2 on RS232 connected to Pin 25 and Pin 3 on RS232 connected to Pin 43, I have Pin 20 and Pin 5 on RS232 connected to ground.

    In Interface > RS232 I have attached an image of the selections chosen.

    I will then check for Identity and it comes back with communication failure.

    I've tried to connect up using CAN Boss and I can't get that connect either.

    Is there anything else I can try or do to connect to this device?
    Attached Images Attached Images

  2. #2
    Join Date
    May 2009
    Location
    Minneapolis, MN
    Posts
    300

    Default

    That sounds correct. I like using the EC2096 to verify the wiring is correct. Maybe that isn't the correct Comm port on your computer.

  3. #3
    Join Date
    Aug 2016
    Posts
    26

    Default

    It was the correct COM Port I checked in the device manager, we connected using CAN-Fox to CAN Boss and used the maintenance tool and were able to load the firmware which then allowed us to install the program, I haven't tried to reconnect the RS232 connect to see if it will work or not.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •