Results 1 to 3 of 3

Thread: Controlled Shutdown of Cr0233 using SUPPLY_SWITCH

  1. #1
    Join Date
    May 2009
    Posts
    87

    Default Controlled Shutdown of Cr0233 using SUPPLY_SWITCH

    Working on a project where the customer wants to kill power to the control system if the machine is left idle for a specified time period. Is there any issue/concern with running the machine by physically removing supply power from VBB15 & using the SUPPLY_SWITCH system variable to keep the Cr0233 powered up? This will allow the ability to use a MCR controlled by a Cr0233 output & power the entire system off via SUPPLY_SWITCH.

  2. #2
    Join Date
    May 2009
    Location
    Minneapolis, MN
    Posts
    295

    Default

    There isn't any issue with that. I have a few systems setup this way to do a delayed shut down.

  3. #3
    Join Date
    May 2009
    Posts
    87

    Default

    Thanks for the feedback

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •